30 Assembling and Maintaining the RBK 615 Recumbent Exercise Bike
4. Using the wire tie you removed in step 1, bind together the
upper ends of all cables.
Note: A fish tape can be helpful in the following step.
5. Place the upright support on the floor with its lower end
next to the body assembly. Thread the cable or cables
upward through the support, then use the wire tie to
secure the upper connectors of the cables at the top of
the support.
Note: In the following step, do not remove the extra serial
number label from its backing.
6. Remove the extra serial number label from the upright
support channel on the body assembly. Set the label
aside; you will be attaching it later in the installation.
To Next Page
Loading...
