Install add-on weight assembly
Figure 5
1. Insert the lower end of the 14 mm guide rod into the retaining ring at the bottom of the
weight tower frame.
Note: The end of the guide rod with the screw hole in it should face up.
2. Slide the 287 mm support tube onto the guide rod from the top down.
3. Slide the support ring onto the guide rod, followed by the rubber bumper.
4. Slide the 7.5 lb (3.5 kg) add-on weight onto the guide rod, making sure that the groove is at
the top end of the weight.
5. Attach the top of the guide rod to the bracket at the top of the weight tower frame using:
1 – M10 x 25 mm hex head bolt
1 – 11 mm flat washer
6. Fully tighten the M8 set screw in the retaining ring using the S4 hex key.
Route the cable
Figure 6
1. Remove the cable socket and the cable end cover from the end of the cable.
2. If the cable assembly is not attached to the weight stack stem, then screw one end of the
cable assembly into the top of the weight stack stem.
CAUTION: Be sure at least seven (7) turns/threads are engaged.
3. Pull the cable through the top of the weight tower frame, over the top of the dual pulleys,
and under the cable retaining brackets. Thread the cable down through the tower frame.
4. At the bottom of the weight tower frame, thread the cable through the lower pulley bracket
and under the pulley.
5. Under the seat on the seat frame, thread the cable through the pulley bracket.
6. Thread the cable through the slot in the seat post frame and under the lower pulley bracket
attached to the seat frame assembly.
7. Thread the cable under and over each pulley between the movement arm and seat frame.
8. Screw the end of the cable anchor into the fitting on the seat frame. Be sure that at least
seven (7) threads are inserted into the fitting. Then, tighten the jam nut to the fitting.
CAUTION: At least seven (7) turns/threads must be inserted into the fitting before tightening
the jam nut.
9. Slide the cable end cover over the cable end and down the cable a few inches. Slip the ball at
the end of the cable into the slot in the socket, then insert the cable anchor into the slot.
10. Position the cable end cover over the socket, then insert the bolt through the holes in the
cover, the socket, and the anchor. Attach the nut to the bolt and tighten completely.
©2021 Precor Incorporated | VSL Leg Press/Calf Extension| Assembly Guide | P/N CWR107777-102 ENU 31 July 2021 | 3
To Next Page
Loading...
