6
Step 5: 1) Insert filter holder by placing handle
under the center of the placing handle
under the center of the Espresso Maker.
Push it upward so it will be aligned with
matching slots.
2) Turn handle to the right until securely
locked.
DO NOT REMOVE FILTER
HOLDERDURING THE BREWING
PROCESS AS SCALDING MAY OCCUR.
Step 6: 1) Place cover on carafe and set it on drip
plate.
2) Plug into 120V AC electrical outlet.
3) Turn selector knob to the Espresso
position (counter clockwise).
4) In about 4 minutes, the espresso will
start to flow into the carafe.
Important: For cappuccino, refer
immediately to the next 2 sections.
For espresso, continue with next
step.
5) When coffee has stopped flowing, turn
selector knob to OFF position.
Step 7: Before removing reservoir cap, turn the
selector knob clockwise to relieve any
pressure.
To Next Page
Loading...