Preparing
Below setup guide just for Repeater Mode by smart
phone & WPS method.
For AP (Access Point) Mode & troubleshoots, please
refer to USER MANUAL.
1. The router/AP works normal.
2. Switch the side button of E300 into “ON” & “Repeater”
Mode.
3. Plug the E300 into an electrical outlet.
Smart Phone Setup Guide
1. Power on the E300 next to your Router.
2. Disable your smartphone’s own Wi-Fi signal.
3. Connect the smartphone to “E300”.
4. Once connected, please visit:
http://extenderlogin.com. (admin page not available?
visit the troubleshoots on USER MANUAL)
5. When prompted, set your own password for the admin
page twice.
6. Click “Wizard” & choose the your router SSID, fill in the
Wi-Fi Password of your router, then click “Connect”.
7. It is around half a minute to reboot the E300. You can
connect back the new SSID of E300 by locating the
suitable place you need (how to locate the repeater
please refer to the troubleshoots in USER MANUAL).
Note: Once setup successful, the WLAN LEDs would
change into Lit Green.