32/108
Upper limit of antifoul: Measurements are expressed in mm.
These measurements are for 'light boat'.
WETTED AREA: 33 M²
PRECAUTION
- Consult the harbourmaster's office to find out the conditions of water use and the
maintenance area for cleaning your vessel.
- It is necessary to seek the advice of your concessionnaire with regard to gel-coat repairs.
PRECAUTION
- When applying the anti-fouling paint do not paint over the electronic instrument sensors
nor the anodes.
ADVICE - RECOMMENDATION
- During the refit, check the anodes.
- When the boat is stored at a dry dock, the corrosion protection is not as effective due to
oxidation of the anodes: even the new anodes oxidize the surface. Before returning the
boat into the water, clean the anodes.
- Cleaning anodes: Use sandpaper.
Do not use metal brushes or steel tools to clean the boat, it may damage the galvanic
protection.
- Replacing the anodes: The anodes are fastened with screws and nuts. First, remove the
screws and nuts that hold the anode, then clean the contact surface. Press the new anode
to obtain a good electrical contact.
333
159
124
To Next Page
Loading...
