CHECKING OF THE 230 V CONSUMING APPLIANCES
110 V - 230 V ELECTRICAL PANEL (entrance of the wheelhouse)
This panel has sliders which enable you to choose the supply source for the
different 110 V - 230 V consuming appliances on board.
LEFT SELECTOR:
- allows to use the devices on board supplied with a 110 V - 230 V current
coming from the generator or the shore.
RIGHT SELECTOR:
- allows to use the air conditioning powered by a 110 V - 230 V current coming
from the generator or from the shore power.
110 V - 230 V PROTECTION PANEL (board in the passage way)
This area groups together 2 buses of automatic breakers of the 110 V - 230 V
appliances and equipments.
The UPPER bus is relevant for the POWER bus on board appliances.
The LOWER bus is relevant for the AIR CONDITIONING bus and the UTILITY bus
on board appliances.
Nota: all the automatic breakers of the 110 V - 230 V circuit are bi-polar
automatic breakers.
USE OF THE 110 V - 230 V POWERED APPLIANCES
TO SWITCH ON THE APPLIANCES
In order to be able to use the 110 V - 230 V powered appliances (dishwasher
grill, etc.), it is advisable:
- To make sure that the automatic breakers are turned to OFF on the 110 V
- 230 V selection panel.
- Switch on the 110 V - 230 V source (start the generator or connect the shore
power socket to shore).
- Select this source on the electrical panel so that this source can supply the
boat (110 V - 230 V Selection electrical panel).
- Push the automatic breaker of the appliance to be used (dishwasher, grill,
etc.) on the electrical panel.
Then start the appliance with its own controls.
To start 110 V - 230 V elements, wait for 10 to 15 seconds between the start
up of each new component (in order to allow the generator to become stabili-
zed and be able to give the power necessary for the starting up).
6
73
Electricity
To Next Page
Loading...
