2
Remove dry erase marker from the holder on the front of the
slow cooker before cooking. If the marker is left in the holder
during cooking, it may not write. Should this occur, position the
marker flat on the counter and allow it to cool. Usually, after
2 to 3 hours, the marker will write again.
Important Cord and Plug Information
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit
into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician. Do not attempt to modify the plug in any way.
A short power supply cord is provided to reduce the risk of becoming entangled in or tripping over a longer cord. DO NOT USE WITH
AN EXTENSION CORD.
Connect the power supply cord to a 120VAC electrical outlet only. To avoid risk of draining vehicle battery or blowing a vehicle fuse,
do not plug slow cooker into vehicle AC outlet.
Before First Use
• Remove all packing material and become familiar with the slow
cooker (Fig. A).
• Read the instructions carefully before use.
• Clean the cover with a damp, soapy cloth. Do not immerse the
cover in water. Wash the removable cooking pot and utensil holder
in warm, soapy water. Rinse and dry thoroughly. (See below for
instructions on removing the utensil holder from the cover.)
CAUTION! To avoid electrical shock, never pour water into the
slow cooker base or immerse it or the power cord in water. Always
be sure the cooking pot is completely dry before placing it back
in the slow cooker base.
CAUTION! This appliance is not intended to melt wax, gels,
plastics, glue, or other materials for making candles or for other
hobbyist activities, or in any commercial or business application.
Using this product for purposes different from those specied in
this instruction manual may cause serious bodily injury or damage
to the product.
Features of the Nomad
®
Slow Cooker
• Dry erase board and marker. Use to identify or describe the
food in the slow cooker. Any markings made on the board can
simply be removed with the eraser on the marker cap. To extend
the life of the marker, make sure the cap is always tightly closed.
Always erase the board prior to storing the slow cooker. Remove ghosting or
smudging with a commercially available whiteboard cleaner or rubbing alcohol.
Be sure to use only dry erase markers on the board.
• Removable utensil holder. Easily lift from the cover and use as a spoon rest. When
the utensil holder is removed, the viewing area to monitor cooking is enlarged.
To remove the utensil holder, first position the unit so the control is facing you. Next,
move the carrying handle to the unlocked position, either toward the front or the
back. Then, lift up on the right side of the utensil holder and remove it from the cover
(Fig. B). If desired, remove the silicone cord before resting a utensil on the holder.
To reattach the silicone cord to the utensil holder, put the cord on top of the holder.
Fit the cord under one set of tabs, twist the cord once, then stretch it and secure the
cord under the other set of tabs (Fig. A).
Temperature
control knob
Removable cooking pot
Dry erase
marker with
eraser
Carrying
handle
Removable cover
Seal-tight
cover gasket
Dry erase board
Slow cooker base
Fig. A
Maximum fill line
Utensil holder
NOMAD
®
logo
Silicone cord
Large tab
Set of tabs
Set of tabs
Hinge
Hinge slot
Removable utensil
holder with silicone cord
Cover
lifting tab
Fig. B
Cover
lifting tab
Dry erase board
Dry erase marker
with eraser
Grommet
To Next Page
Loading...
Need help?
General
