CONTROLS/INSTRUMENTS
2 - 21
4*. Incline
Pull handle up, and adjust seat inclination.
Warning: Before proceeding with seat cushion
adjustments, lower seat belt retractor to avoid
pinching fingers between retractor and control
knobs.
(*) If your vehicle has electric seats, controls 3 &
4 change. For description of electric controls,
see Electric Seats "ISRI" on this page.
5. Suspension
For maximum suspension performance, push
or pull knob until desired damping is
reached.
6. Raise/Lower
Press on + or - to respectively raise or lower
driver's seat.
7. Lumbar Support
Push on upper section of rocker switches to
inflate lumbar support bellows inside the seat
backrest, and push on lower section of
rocker switches to deflate bellows.
Note: Rear and front rocker switches are
respectively for upper and lower lumbar support
bellows.
Heated Cushions
The "ISRI" seat may also be equipped with back
and seat heated cushions, operated by a switch
mounted on R.H. lower switch panel (See item
#7 on page 2-14).
Electric Seats "ISRI"
Adjust electric seats as follows:
1. Tilt (rear)
Pull switch up to raise rear section of seat.
Push switch down to lower rear section of
seat.
2. Fore-and-Aft - Up/Down
Push switch towards dashboard to move seat
forwards or back to move seat backwards.
Pull switch up to raise seat & push switch
down to lower seat.
3. Tilt (front)
Pull switch up to raise front section of seat.
Push switch down to lower front section of
seat.
18040
4. Memory
- Use switches (items 1,2 & 3) to adjust the seat
to the position desired by driver "1".
- Press the "SET" button and then the number
"1" button. Memory position "1" is now set.
- To set the seat position for driver "2",
repeat steps 1 and 2 except press the
number "2" button in step 2. Memory
position "2" is now set.
- To move the seat to either memory position,
press and hold the desired button ("1" or "2")
for at least 2 seconds. If the seat does not
move, the button was not held long enough or
the seat is already in the desired position.
- To use the easy entry/exit feature, press and
hold the number "1" and the number "2"
buttons at the same time for at least 2
seconds. The seat will move to the full rear
and full down position.
- To stop seat movement, push any control
button (items 1 to 4).
Note: The seat can, at any time, be positioned
using items 1,2 & 3 without affecting the two (2)
memory positions.
To Next Page
Loading...
Need help?
General
