PREVOST X3-45 COMMUTER User Manual

SECTION 18: BODY
DOB 1300-1556 | X3-45 Commuter PA-1648 Maintenance Manual First release Oct 2020
19
Surface Preparation
Sand using P-
150 grit sandpaper.
It is recommended to sandblast
rivets and panel edges with
OLIMAG 35-70 blast media.
Sand using P-
180 or
P-240 sandpaper.
Do not use paint remover
over aluminum or fiberglass.
Cleaning
STANDOX silicone remover ST-16203
Priming
STANDOX Reactive Etch Primer
ST-13908
* Wait 30 minutes then apply
STANDOX HS primer ST-15161
STANDOX Non-Stop
Füllprimer ST-11000
(68-2973)
Refer to product Technical
Data sheet for proper mixing
Basecoat
Refer to paint scheme or coach record for proper color code
and paint brand.
We recommend using the same paint brand to ease color
matching.
Refer to product Technical
Data sheet for proper mixing
Clearcoat
Axalta Imron Clear 8430 S
Allow 16 hours for drying
Refer to product Technical
Data sheet for proper mixing
NOTE
Product listing above is based on factory applied products. Local VOC (Volatile Organic Compound)
regulations may vary, consult your paint supplier and use a VOC compliant product that matches the
factory recommendations if required to do so.

PREVOST X3-45 COMMUTER Specifications

General

Engine	Volvo D13
Transmission	Allison B500
Fuel Type	Diesel
Length	45 ft (13.7 m)
Width	102 in (2.6 m)
Horsepower	500 hp
GVWR	54, 000 lbs
Height	141 in