Pride Mobility 39 - User Manual

Questions and Answers

A
Allison KingAug 15, 2025
What to do if all systems on my Pride Mobility Travel Scooter seem dead?
- T
  Taylor HaynesAug 15, 2025
  If all systems on your Pride Mobility Travel Scooter appear to be “dead”, ensure the key is in the “on” position, the batteries are fully charged, and the main circuit breaker reset button is pushed in. Also, check that the battery pack is seated properly and that the battery and front-to-rear harnesses are connected correctly (Models 36, 83, and 84 only). Make sure the power down timer feature hasn't been activated, and inspect the tiller console fuse located under the battery pack.
B
Betty RoseAug 18, 2025
What to do if the battery condition meter dips and the motor surges on my Pride Mobility Travel Scooter?
- J
  John GonzalezAug 18, 2025
  If the battery condition meter dips way down and the motor surges or hesitates when you press the throttle control lever on your Pride Mobility Travel Scooter, fully charge your Travel Scooter’s batteries. You can also have your authorized Provider load test each battery.
G
gfischerAug 21, 2025
What to do if the Pride Mobility Travel Scooter’s batteries won’t charge?
- E
  Erin WilliamsAug 21, 2025
  If your Pride Mobility Travel Scooter’s batteries won’t charge, check the fuse located on the battery pack or the console and replace it if necessary. During charging, if the charger LEDs never indicate a full charge, check the same fuse and replace if needed. Ensure both ends of the charger power cord are connected properly. If the battery pack fuse continually blows, contact your authorized Provider for service.
S
Shannon GoldenAug 25, 2025
Why does the main circuit breaker repeatedly trip on my Pride Mobility Travel Scooter?
- M
  Michael LaneAug 26, 2025
  If the main circuit breaker trips repeatedly on your Pride Mobility Travel Scooter, charge the Travel Scooter’s batteries more frequently. If the problem continues, have both of your Travel Scooter’s batteries load tested by your authorized Provider. You may also perform the load test yourself.
S
Scott SmithAug 28, 2025
What to do if the Travel Scooter's battery voltage is too high on my Pride Mobility Travel Scooter?
- R
  reginajohnsonAug 28, 2025
  If the Travel Scooter's battery voltage is too high to operate the scooter, or the charger is still connected to the off-board charger port on your Pride Mobility Travel Scooter, unplug the charger and/or turn the key off, then back on again. If traveling down a slope, reduce the Travel Scooter speed to the minimum setting.
A
Andrew CarpenterAug 31, 2025
What to do if the battery charge is too low on my Pride Mobility Travel Aid?
- A
  andrew58Aug 31, 2025
  If the battery charge is too low on your Pride Mobility Travel Aid, charge the batteries.
T
Tanya Phillips DDSSep 4, 2025
What to do if the manual freewheel lever is in the freewheel position on my Pride Mobility Travel Scooter?
- M
  Margaret LopezSep 4, 2025
  If the manual freewheel lever is in the (forward) freewheel position on your Pride Mobility Travel Scooter, remove the key from the key switch, then push the manual freewheel lever to the drive (rearward) position and restart your Travel Scooter.
J
John SmithSep 7, 2025
What to do if the battery voltage is too low to operate the Pride Mobility Travel Scooter?
- A
  Adam KennedySep 7, 2025
  If the battery voltage is too low to operate the Pride Mobility Travel Scooter, charge batteries as soon as possible.
L
Lori ThomasSep 12, 2025
What to do if throttle control lever is not at center position at start up on Pride Mobility Travel Scooter?
- B
  Barbara LopezSep 12, 2025
  If the throttle control lever is not at the center position at start up on your Pride Mobility Travel Scooter, verify that the batteries are fully charged. If the batteries are fully charged, then return the throttle control lever to the center position, turn the Travel Scooter off then back on.