Pride Mobility EA1065-P - Page 39

39
OPERATING INSTRUCTION
(1) Make sure the battery charger output voltage is the same as the connecting battery.
 (2) Pluginthepowercord.LEDindicatorashesgreenwhenACpoweron.
(3) Connect the battery charger to the battery.
(4) Start charging; please refer to 4, LED INDICATION.
LED INDICATION
 (1) Greenash:poweron
(2) Orange: charging
 (3) Orangeash:precharge
 (4) Green&orangeash:charged80%
(5) Green: full charged (cloating charge)
 (6) Redash:defect
TROUBLESHOOTING
(1) If green indicator is off:
- Check AC input. If it works normally, the battery charger may be defective.
 (2) Ifgreenindicatorkeepsashing,can’tturntochargingindication:
- Check if the battery connects successfully.
- Check if the output connection is short or open.
- If the battery connection is normally, the battery charger may be defective.
 (3) Ifredindicatorkeepsashing:
- Check if the battery connection is reversed.
- Check if the output connection is short or open.
- Check if the environment temperature is too low (-25”C).
  -Iftheredindicatorstillkeepsashing,thebatterychargermaybedefective.
(4) Charging indicator (orange) can’t turn to green:
- The battery might be defective. Please stop charging and have the battery repaired.
(5) If the charging indicator (orange) turns green (fully charged) immediately:
- The battery may be in well-charged condition.
- If the battery is not fully charged, the battery may be defective.
CAUTION
(1) Before using the battery charger, read all instructions and cautionary markings.
(2) Use the battery charger in a well-ventilated area.
(3) To avoid the risk of injury, charge only lead-acid or gel cell type rechargeable batteries.
(4) Please turn off the power after charging.