portant safety Instructions
This unit is equipped with apolarized alternating-current line plug (a plug having one blade
wider than theother). This plugwill fit intothe power outlet only one way. This isa safety
feature. If youare unable to insert the plugfully into theoutlet, try reversingthe plug. Ifthe
plug should stillfail to fit,contact your electricianto replace yourobsolete outlet. Insteadof
the polarized alternating-currentiine plug, yourunit may beequipped with a3-wire
grounding-type plug (aplug having athird (grounding) pin). This plug willonly fit intoa
grounding-type power outlet. This too, isa safety feature. If you areunable to insertthe plug
into the outlet, contact your electricianto replace yourobsolete outlet. Donor defeat the
safety purpose ofthe grounding-type plug.
12, POWER-CORD PROTECTION
Power-supply cords shouldbe routed sothat they arenot likely robe walked onor pinched
by items placedupon or againstthem, paying particularattention to cordsat plugs,
convenience receptacles, andthe point wherethey exit fromthe appliance.
13, LmGHTNmNG
Toprotect your unitfrom a lightningstorm, or whenit is leftunattended and unusedfor long
periods of time, unplug it fromthe wall outletand disconnect theantenna or cablesystem.
This will preventdamage to theunit due tolightning and powerline surges.
14, POWER UNES
An outside antennasystem should notbe located inthe vicinity ofoverhead power linesor
other electric lightor power circuits, or where itcan fall onto or against such power lines or
circuits, When installingan outside antennasystem, extreme careshould be takento keep
from touching suchpower lines orcircuits, as contactwith them mightbe fatal.
t5, OVERLOADING
Do not overload wall outlets andextension cords, asthis can resultin a riskof fire orelectric
shock.
18, OBJECTAND LmQUmDENTRY
Do not pushobjects through anyopenings in thisunit, as theymay touch dangerousvoltage
points or shortcut parts thatcould result infire or electricshock. Never spillor spray any
type of liquidinto the unit.
17, OUTDOORANTENNA GROUNDmNG
If an outsideantenna or cablesystem is connectedto the unit, be SUre theantenna or cable
system is groundedto provide someprotection against voltagesurges and built-upstatic
charges, Section 810of the NationalElectrical Code (NEC),ANSI/NPPA70, provides
information with respect to proper groundingof the mastand supporting structure,
grounding of thelead-in wire roan antenna discharge unit, size ofgrounding conductors,
location of antennadischarge unit, connectionto grounding electrodes,and requirements
for the grounding electrode.
ELF#_rI_OOE SyS1XM
t8, SERVICING
Do not attemptto service this unit yourself asopening or removing covers may expose you
to dangerous voltageor other hazards. Refer all servicingto qualified service personnel.
19, DAMAGE REQURRINGSERVmCE
Unplug this unitfrom the walloutlet and referservicing to qualifiedservice personnel under
the following conditions:
a. When thepower-supply cord orplug is damaged.
@
To Next Page
Loading...
