Fault
Possible Causes
Solution
The appliance
is not working
Food ingredients
are not crushed
properly
Used for a long time continuously
and the motor unit is protected
from overheating
The food processor is overloaded
Too much or too few food
ingredients added
Check if the voltage is too low
Blender cup or lid is not
assembled correctly
Blender cup or lid is not in
the right place
Voltage too low
Reduce the amount of food, follow
the user instruction on maximum
amount of food allowed
Follow the recipe instructions on
ingredient portions
Unpleasant odor
Odor is considered normal
during initial use of the
product when the motor unit
is warming up
Abnormal noise
generated in
operation
Switch off the machine and remove
the blender cup, Examine if any
foreign object inside and
re-assemble the blender cup
and lid again
Remove and reposition the
blender cup and lid in the right place
Allow the motor unit to cool down
at room temp for approx. 30 minutes
Follow the user instruction on
operating time
The odor will gradually disappear
after several uses of the product.
It is recommended to place the
product at well-ventilated area to
allow the odor to be adequately
dispersed
Indicator light
does not come on
Indicator light failure
Blender cup is not assembled
on the motor unit properly
Check and make sure the appliance
is connected with power supply
Try assemble the cup and motor unit
properly
Heating but not
stirring
Circuit board malfunction
Repair service
Incorrect program selection
Overflow or
scorched bottom
Too much food ingredients
Follow the recipe instructions on
ingredient portions
Blender cup is not cleaned
thoroughly
Clean the blender cup thoroughly
before using it again
Please use this chart to troubleshoot common problems using PS810 Intelligent
Food Processor.
EN
27
To Next Page
Loading...