Strutting Gobbler Decoy
Model No. 69021
Visit our website at primos.com.
WARNING: Killer B
™
is so realistic, you need to use a blaze
orange safety flag when carrying him through the woods.
Step 1
Step 2
Step 3
“Killer B
TM
is so Realistic and Mobile that you will have
gobblers strutting in your lap!”
(Large washers are used on the Fan Holder) - 1. Place washer onto bolt.
2. Place the Fan Holder onto the bolt. 3. Place the second washer on the
bolt. Hand tighten wing nut to desired tension.
ASSEMBLY OF MOBILE
™
SERIES REAL FAN HOLDER -
Your rst step to create your real fan using the Mobile
™
Series Fan Holder is to cut the real turkey fan where the
tail feathers meet the body. Take one of the fan feathers and pull straight back to remove the feather. There will
be some meat on the end, scrape the meat off with a knife. If the end of the quill is too long just cut it off so the
feathers will be even.
The process takes approximately 20 minutes to complete your fan. A gobblers normal tail fan has 18 feathers. The
Mobile
™
Series Fan Holder utilizes 16 feathers.
INSTALLING THE MOBILE
™
SERIES REAL FAN HOLDER ON KILLER B
™
-
2 Washers
To Previous Page
Loading...