3. Check the seals before connecting a new gas container to the appliance. Do not use the
appliance if it has damaged or worn seals.
4. The threads on both the gas cartridge and the regulator,
must be intact if they are damaged
in any way or awry, replace the gas cartridge; or if the regulator is damaged, DO NOT USE the
stove. Order a new hose and regulator – see Accessories on the side flap.
5. Inspect the hose (so that it is neither kinked norsquashed. Avoid twisting the flexible hose) as well
as the connections to the burners that they are not damaged. Lift the pan support
and drip
tray
to ensure that the hose and connector are properly adjusted. Maximum hose length to
be used: 2000 mm. Check that the cartridge is empty before changing it (shake to hear the noise
made by the liquid)
PREPARE THE STOVE. Important: Take care
to ensure that the stove is standing on a stable, at surface with no
combustible material nearby. Check its stability! If you tip the stove
while there are pots on it, you risk being scalded by hot liquids.
1. Stand the stove on its side with the handle
uppermost. Remove the regulator and hose from
the slot on the underside.
2. Place the stove on a flat surface.
3. Open the lid on the stove by angling the lever 90°.
It is important that the lever is pointing
straight up, otherwise the lid cannot be opened. Lift the lid as far as it will go.
4. Fold out both wind shields
to their outermost position.
5. In transportation mode, the pan support
is upside down. Turn the pan support so that the
rough sides are uppermost, towards the pot. Ensure that the metal pins on the edges sit in the
holes in the drip tray.
55086_3_Alika_inlay.indd 1055086_3_Alika_inlay.indd 10 2023-10-13 10:202023-10-13 10:20
To Next Page
Loading...