4. Change the pads.
5. Activate the brakes as instructed earlier.
6. Use UP/DOWN button to select Adaptation from Select Function menu and press ENTER
button.
>5) Adaptation
6) Function Test
7. Wait a few seconds until following screen shows:
03mm
DOWN Button or UP button = Change
N = Exit Y = Confirm
8. Use UP/DOWN button to enter new pad thickness, and press ENTER button to confirm.
If you want to quit the setting, press EXIT button and a “Command Cancelled!” message
comes up.
9. An Adaptation done message comes up on screen indicating the setting is performed
successfully. If the setting is not carried out successfully, an Adaptation Failed message
shows. Repeat steps above to try again.
10. Wait a few seconds or press any key to return.
11. Turn the ignition off.
Function Test (Audi)
This confirms the brake calipers are functioning properly after being serviced.
1. Use UP/DOWN button to select Adaptation from Select Function menu and press ENTER
button.
5) Adaptation
>6) Function Test
Diagnose EPB On Other Audi’S Models
Reading Codes
1. Use UP/DOWN button to select Other Audi from AUDI Menu and press ENTER button to
confirm.
1) Audi A8
>2) Other Audi
2. Use UP/DOWN button to select Read Codes from Select Function menu and press ENTER
button to confirm.
>1) Read Codes
2) Erase Codes
3) Deactivate Brake
4) Activate Brake
3. View DTCs and their definitions on screen.
4. If more than one DTC is found, use UP/DOWN button, as necessary.
If no codes are detected, a “No codes are stored in the module!” message displays on the
screen. If a code appears with no definition refer to the vehicles service manual. Additionally
the internet has the code definitions and possible solutions.
5. Press EXIT button to return to previous menu.
To Next Page
Loading...