Make sure the vehicle is properly blocked before activation of the system.
1. To close the brake pads after finishing the maintenance/service work on the brakes, use
UP/DOWN button to select Activate Brake from Select Function menu and press ENTER
button.
1) Read Codes
2) Erase Codes
3) Deactivate Brake
>4) Activate Brake
2. Wait while the tool is activating the brakes, you may hear the calipers opening. When they
are activated successfully, Activation done, Press any key to continue message displays.
If the Activation failed message does not go away, then contact your local distributor or the
manufacturer’s customer service department for assistance. If a Selected function is not
supported message shows on the display,
Check that the park brake is released;
Repeat the process.
Change Brake Fluid
EXTREME CAUTION: The following information is for operating the W3000 when servicing or
replacing brake fluid. This process should only be done by an experienced technician using a
factory service manual. Extreme high pressure is involved.
WARNING: Do not operate the brake pedal until you are prompted to!
Make sure the central lock is deactivated! Use extreme caution during the whole bleeding
process as the pressure of pump bleed screw will be up to 100 bar (1450 psi.)!
1. To complete the brake fluid change process, make sure vehicle battery is fully charged and
is in good condition. It may be necessary to connect a charger to vehicle battery.
2. Prepare at least 2.0 liters (2.11qt) of brake fluid and pour the liquid into brake fluid
accumulator.
3. Connect the fluid accumulator to brake’s master cylinder with the accumulator tube.
4. Plug the device to vehicle DLC and turn ignition on.
5. Use UP/DOWN button to select SBC-Mercedes from Diagnostic Menu press ENTER button
to confirm.
1) EPB-Audi A8
2) EPB-Other VAG
>3) SBC-Mercedes
4) PBM-Volvo
6. Use UP/DOWN button to select Change Brake Fluid from Select Function menu press
ENTER button.
>5) Change Brake Fluid
6) Inspect Brake Air
7) ECU Information
Diagnose SBC On Mercedes Cont.
Important: To complete the brake fluid change process, vehicle battery must be fully charged
and in good condition. The W3000 will monitor battery voltage during the whole process. If the
To Next Page
Loading...