Environmental Compliance
Waste Electrical and Electronic Equipment (WEEE) Directive
In the European Union, this label icon indicates that this product should not be disposed with the household waste. Prinker Korea products are subject to this
directive and therefore you should always collect them separately and bring them to the appropriate electronic waste collection point in our community or
region to enable recovery and recycling. Please, refer to the community center for information on how to recycle electronic waste responsibly in your region.
Declaration of Conformity
Hereby, Prinker Korea Inc. declares that the radio equipment type PRINKER S and its variants follows Directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address: http://prinker.net
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Note 1. Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
Note 2. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
R-C-PRk-PRINKERS
To Next Page
Loading...