Prio Expert MOD600 - System Benefits; How the System Works

4
Direct Flow R.O. Systems Benets:
Powerful booster pump and high-production R.O. membrane make it possible to build a high-
end direct ow R.O. machine that oers high performance and water quality.
■
Freshness of water ltered in real time. No more stale water from a tank.
■
Virtually unlimited ltered water production. While conventional systems with tanks are
limited by the tank capacity, and require prolonged timeouts to rell the tank, a direct ow
system is limited by the membrane ltration rate only.
■
Instant and sustained ltered water ow. It doesn’t depend on how full the tank is.
■
Space-saving, compact installation since tank is not needed.
■
Better water purication quality due to improved contaminant rejection rate.
■
Typically, up to three times less water is wasted per gallon of ltered water, compared to
the conventional tank and water storage systems, this is due to the much higher eciency
(recovery) rate. Saves you money and Planet Earth’s water resources!
■
Lower cost of ownership due to prolonged service life of pre-lters and membrane, which
is in turn a result of higher eciency rate: less water is treated overall by pre-lters and
the membrane for each gallon of permeate produced. This saves the capacity of pre-lters
and ensures either less frequent change necessity or better purication.
■
Less number of components leads to better reliability.
How It Works:
The MOD600 direct ow reverse osmosis system is a multi-stage automatic ltration machine.
The system consists of the two main units – the pump box and the R.O. unit – which are con-
nected with three tubes. This inter-unit connection distance is up to 50 . Water supply is done
through the inlet valve, ltered water is delivered through the faucet, and waste water is drained
through the drain saddle. Deta led connection scheme is shown on the following charts.