23
HOW TO CONNECT YOUR HEART RATE MONITOR
TO THE CONSOLE
The console is compatible with all Bluetooth Smart
heart rate monitors.
To connect your Bluetooth Smart heart rate monitor to
the console, press the iFit Sync button on the console;
the console pairing number will appear in the display.
When a connection is established, the LED on the
console will flash red twice.
Note: If there is more than one compatible heart rate
monitor near the console, the console will connect to
the heart rate monitor with the strongest signal.
To disconnect your heart rate monitor from the console,
press and hold the iFit Sync button on the console until
the LED on the console turns solid green.
Note: All Bluetooth connections between the console
and other devices (including any tablets, heart rate
monitors, and so forth) will be disconnected.
HOW TO USE THE SOUND SYSTEM
To play music or audio books through the console
sound system while you exercise, plug a 3.5 mm male
to 3.5 mm male audio cable (not included) into the jack
on the console and into a jack on your personal audio
player; make sure that the audio cable is fully
plugged in. Note: To purchase an audio cable, see
your local electronics store.
Next, press the play button on
your personal audio player.
Adjust the volume level using
the volume increase and
decrease buttons on the con-
sole or the volume control on
your personal audio player.
THE SETTINGS MODE
The console features a settings mode that keeps track
of treadmill usage information and allows you to select
a unit of measurement for the console.
To select the settings mode, insert the key into the
console while holding down the Stop button. Then,
release the Stop button. Note: If a workout has been
selected, you may have to press the Stop button twice
to exit the workout before you can access the settings
mode. When the settings mode is selected, the follow-
ing information will be shown:
An “E” for English miles or an “M” for metric kilometers
will appear in the display. Press the Speed increase or
decrease button to change the unit of measurement, if
desired.
Press the Stop button once to view the calibration
screen. Press the Incline increase or decrease button
to calibrate the incline system.
To exit the information mode, remove the key from the
console, or press stop repeatedly.
To Next Page
Loading...
Need help?
General