Pro-Ject Audio Systems Measure It - Maintenance and Specifications; Changing Batteries; Technical Specifications; Product Context

To Previous Page

Changing batteries

Proceed as follows:

• Slide open the battery case cover

• Replace both batteries together. Make sure the batteries are the right way round

• Refit the battery case cover

Battery type: 2 x LR43 cells, 1,5V

If the stylus balance is not used over a long period of time the batteries should be removed.

Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at the

appropriate collection sites - usually located at supermarkets and drugstores.

Technical specifications Measure it

Capacity 0 - 5g

Variance ±0,002g

Weighting mode gram (1g = 10mN)

Display 4 digit LCD with backlight

Calibration auto calibration using a 5g weight

Auto off 120 seconds off

Replacement battery 2 x LR43, 1,5V

Operating temperature 0 - +40° C

What is in the box

• stylus balance

• calibration weight

• 2 replacement batteries

• protection bag for the meter

• user guide

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions

for use. Modification or change to any part of the product by unauthorized persons release the

manufacturer from any liability over and above the lawful rights of the customer.

PRO-JECT is a Registered Trademark of H. Lichtenegger.

This guide was produced by: Audio Trade GmbH

The information was correct at the time of going to

press. The manufacturer reserves the right to make

changes to the technical specification without prior

notice as deemed necessary to uphold the ongoing

process of technical development.