Regularly check the velvet strips on the arm. Make sure they are clean, no dirt or debris is present.
Potential incorrect use and fault conditions
Pro-Ject products are manufactured to the highest standards and undergo strict quality controls before leaving
the factory. Faults that may possibly occur are not necessarily due to material or production faults but can
sometimes be caused by incorrect use. Some of these faults are as follows:
The platter doesn't turn although the unit is switched on:
• The power cord is not connected to the unit.
• The power cord is not plugged in to the AC wall outlet.
• Broken fuse in the main switch.
• Overheating protection is active.
How to replace vacuum arm strips
Remove the old strip from the vacuum arm and clean the residue of the glue. A transparent plastic tool is
included with the strips in the accessory box, insert the tool fully into the groove and it will help you to place
the new strip into its position on the arm.
To Next Page
Loading...