Instructions for Use
1. Place sling to be used onto spreader bar without
patient/resident/user.
2. Press the scale faceplate On/Zero button to zero-out the sling
weight (this weight will remain zeroed out until the Off button is
pressed).
3. Press the Lb. button to select mode you prefer.
4. Carefully lift the patient/resident/user in the sling, performing
the procedure so that all of the weight is supported by the lift.
Stabilize th
e movement of the sling after lifting.
5. Weight will display on the scale. Press the Operate/Hold button
to hold the weight displayed. To reset the scale to zero, press the
Operate/Hold button again.
6. Lower patient/resident/user safely.
7. If you are weighing another individual using the same sling,
perform the lift and their weight will display. Press Operate/ Hold
to maintain their weight on the scale display.
8. Press
the Off button when the weighing procedure is complete.
9. The scale will automatically power off five minutes after
measurement has been completed.
To Next Page
Loading...