13) Place the shelf on the lower extrusions in the front of the table allowing the T-nuts to drop in the
channels on the top of the extrusions. Tighten the M5 x 18mm screws.
14) Next, lift each leg individually and thread your feet or casters to the appropriate, level, height.
15) Use the eight remaining T-nuts and M5 x 20mm socket cap screws to secure your machine to
the table using the holes provided at the bottom of each of the machines feet.
16) Now place the protective black plastic end caps on the top of the square 60/60 extrusions and
the ends of the two longest cross bar extrusions.
To Previous Page
Loading...
