10
4. Rell with potable water as described in chapter “Make
ice cubes”. Since there may still be water in the appli-
ance, check the MAX mark in the water tank.
5. Now put the ice cube container back in and close the lid.
6. Press the button to resume ice cube production. The
control lamp turns off.
Cleaning and Maintenance
WARNING:
• Switch off the appliance before cleaning and disconnect the
mains plug.
• Never immerse the appliance in water to clean it. Doing so may
lead to electric shock or re.
CAUTION:
• Do not use wire brushes or other abrasive implements.
• Do not use harsh or abrasive cleaning agents.
• Do not use chemicals, acids, petrol or oil products.
• For hygienic reasons exchange the water in the tank
after 24 hours.
• Remove the ice cube container after use. If the water
tank remains open no mould or bacteria can form.
Self-Cleaning
1. Fill the water tank with water up to the MAX mark.
2. Press the
button. Select the cleaning programme
with the button. The control lamps and light up.
3. After the programme is nished, the appliance switches
back to standby mode and all control lamps go out.
Ice Cube Container
Remove the ice cube container. Clean it in warm rinse water
with a little hand dishwashing liquid. Rinse with clean water.
Housing and Interior
• Clean housing and interior with a damp cloth.
• Use a diluted solution of vinegar and water.
Drain Residual Water
Drain the residual water if the appliance is not in use for a
longer period of time. Rest the appliance on a table edge.
Take a bowl and hold it under the drainage opening for the
residual water.
• Pull out the cap at the bottom.
• After the remaining water has drained off, put the cap
back into the opening.
Storage
• We recommend that you keep the appliance in the
original packaging if you do not intend using it for long
periods.
• Always keep the appliance out of the reach of children in
a dry, well-ventilated place.
Troubleshooting
Problem Possible Cause Solution
No function. No power supply. Test the socket with another appliance.
Plug in the mains plug correctly.
Check the main circuit breaker.
The appliance is faulty. Contact our service centre or a specialist.
Compressor noisy. Mains power supply too low. Turn the appliance off and check the mains power supply.
Control lamp
ashes.
Water rell. Add water as described in the chapter “Operation”
“Making Ice Cubes”.
Control lamp
ashes.
The ice cube container is full. Empty the ice cube container.
To Next Page
Loading...