Profline SFM - RF Output Configuration; Audio Settings; ASD Submenu Settings; RDS Submenu Settings

User manual Profline SFM.
© Profline
Specifications are subject to change without notice
RF-OUT
When selecting the submenu "RF-OUT', the following subjects can be adjusted:
- Frequency 87.50 - 108.00 MHz 10KHz steps
- RF out On Off
- RF Level 100.0 - 120.0 dBųV 0.5dB steps
AUDIO
When selecting the submenu "AUDIO", the following subjects can be adjusted:
- Source Mute/ Aux or (when option is installed) Aux/ "Option" (ASD, IQD)
- M/S Mono/Stereo broadcast-mode (see *)
- Left -9 - +6 dB (Audio level)
- Right -9 - +6 dB (Audio level)
* When IQD-option is installed, and the IQ-channel is in mono mode, the program will be broadcasted in
Mono-mode, independent of the Mono/Stereo switch in this sub-menu. .
* When the IQ-channel is in stereo-mode, it is possible to broadcast in mono-mode by means of the
Mono/Stereo Switch in this sub-menu.
ASD (when installed)
When selecting the submenu "ASD", the following subjects can be adjusted:
- Freq.L 6.00 - 8.50 Mhz 10KHz steps
- Freq.R 6.00 - 8.50 Mhz 10KHz steps
- Squelch 70 - 85 dBųV 1 dBųV steps (hysteresis 3dB on/off)
RDS (when installed)*
When selecting the submenu "RDS", the following subjects can be adjusted:
- Source Intern/Extern
- PI 0000 - FFFF Hex. numbers
- M/S Music/Speech
- PTY NONE INFO DRAMA VARIED M.O.R. M
LIGHT M NEWS SPORT CULTURE POP M
AFFAIRS EDUCATE SCIENCE ROCK M
CLASSICS OTHER
When "SOURCE" is selected "INTERN", the name entered in the submenu "NAME" will be broadcasted as RDS-
information. If "SOURCE" is selected "EXTERN", the data from the external RDS data input (EBU SPB-490 protocol) will
be broadcasted. This data input is the COM RDS input, Sub D9 male connector, at the back. Data communication with RS
232, pins 2 (rx) and 5 (gnd) or RS 422, pins 4(+) and 5(-).
* This sub-menu will not be available when an IQD is installed. User manual Profline SFM.