Big Studio Quick Start Guide
1
Turn on the flash head
(you can also use the HEAD button on the remote control)
Turn off after use
2
Check Channel and Group (only when using Profoto remote control):
The number and letter in the display must correspond with the ones on the label
If not: turn the setting knob (7) to set the channel (numbers 1 to 6)
push and turn the setting knob to set the group (A or b)
3 Set Modelling light to PROP (proportional)
4 Set Ready indicator to BEEP
5
Set the Slave function:
RADIO: the flash will respond to the Profoto Remote Control
IR : the flash will be triggered by another flash or an IR remote control
6
Do not change this setting
The value should always be 10
7
Use the Setting knob to adjust the flash value:
Turn for small increments
Push and turn for large increments
Mandatory settings in red, Recommended settings in blue
Most of our flash heads are hanging on the ceiling, so this is how you will see their displays: upside down
To Next Page
Need help?
General
