To Order Call:
1.888.767.2529 Page 2
ALWAYS USE TRAVEL BOLT WHEN MOVING TRAILER
When moving the trailer, re-insert the travel bolt into the center trap.
The bolt secures the center trap for travel and is required to
prevent damage to the unit.
Always remove the travel bolt before operation. Failure to do so will
result in damage to the unit.
Breaker Box
Controls power to the 3
traps and the oscillation
motors. The traps will not
fire when they have been
disarmed and the
switches on this box are
in the “off” position (the
red on the switch is
visible).
Control Box
Arms and disarms the
traps and controls their
vertical and horizontal
movements.
NOTE: The Center Trap
Elevation button is only
present on the Huntsman
Wobble Control Box.
Mounted Receiver
Receives signals from the
wireless transmitter to
control traps & flush
sequences.
Wireless Transmitter
Controls firing of the
traps and starts and stops
the flush sequence.
Uses (4) AA Batteries
CAUTION
This is an automatic machine. Targets may be released at any time.
Failure to read and understand these instructions before using this ma-
chine can result in death, bodily injury or property damage.
Read these instructions completely to insure the traps are DISARMED
properly before loading targets or performing maintenance. If you have
any questions after reading this manual, call Promatic for assistance.
Traps should be DISARMED when the unit is not in use.
Position your body and all body parts behind the unit (tongue end of
the trailer). Never stand in front of or to the sides of the unit.
SEE PAGE 3 FOR INSTRUCTIONS TO DISARM THE TRAPS
To Next Page