12 OPS-M Quick Install Guide
Wi-Fi module
OPS3-5P8R256S and OPS3-7P16R256S incorporate a Wi-Fi module. See compliance label for detailsof the fitted Wi-Fi
module.
United States of America
Model No: OPS3-5P8R256S and OPS3-7P16R256S are open cell personal computers to be used with UL listed panelsthat have
installationsdetailing user installation and card cage accessories.
Thisequipment has been tested and found to comply with the limitsfor a Class B digital device, pursuant to Part 15 of FCC Rules.
These limitsare designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try and correct the interference by one or more of the followingmeasures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and the receiver.
• Connect the equipment to outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Any changes or modifications not expressly approved by the party responsible for compliance couldvoid the user’s authority
to operate the equipment.
Thisdevice complies with part15 of the FCCrules. Operation is subject to the following two conditions:
1. Thisdevice may not cause harmful interference; and
2. Thisdevice must accept any interference received, including interference that may cause undesired operation.
Canada
Canada – Industry Canada (IC)
Model No: OPS3-5P8R256S and OPS3-7P16R256S are open cell personal computers to be used with CUL listed panelsthat
have installations detailing user installation and cardcage accessories.
Thisdevice complies with RSS 210 of Industry Canada.
Operation is subject to the following two conditions:
1. this device may not cause interference
2. this device must accept any interference, including interference that may cause undesired operation of this device.