12 Operation
WARNING!
Fire hazard with flammable media
Only with combustible media: These may start to
burn when combined with oxygen.
– During filling and draining of the liquid end, an
expert must ensure that feed chemical does
not come into contact with oxygen.
This chapter describes all the operating options in a continuous
display (several symbols and the pressure display appear at the
top in the black bar) for the trained person at the pump.
–
Please also refer to the "Operating/Setting
Overview" and "Continuous Displays and Sec‐
ondary Displays" overviews at the end of the
operating instructions and also the "Overview
of Equipment and Control Elements" chapter.
12.1 Manual operation
Stop the pump: Press
[STOP/START]
.
Start the pump: Press
[STOP/START]
again.
Press
[Priming]
.
Turn the
[Clickwheel]
to extend of shorten the priming time during
priming.
In
‘Batch’
operating mode: Press the
[Clickwheel]
in the
‘Push’
continuous display.
Press the
[Clickwheel]
to acknowledge error messages that require
acknowledgement.
In a continuous display: Another continuous display will appear
each time the
[Clickwheel]
engages when turned. (The number
depends on the configuration).
1. Press the
[Clickwheel]
.
ð
The variable can be changed (highlighted).
2. Turn the
[Clickwheel]
.
ð
The variable is changed.
3. Press the
[Clickwheel]
.
ð
The variable is saved (the highlighting disappears).
Stop/start pump
Priming
Starting a batch
Acknowledging errors
Checking adjustable variables
Changing directly changeable varia‐
bles
Changing a variable in the relevant
continuous display:
Operation
96
DosingPump.ir
To Next Page
Loading...
Need help?
General
