5
After entering the programming mode all the previously recorded remote
controls will be deleted from the controller memory. The programmed time of
the open lock time remains saved.
While the controller is in the programming mode, the lock is turned off.
To avoid accidental reprogramming of the controller and deleting of the
database of programmed remote controls, make sure you move the jumper J1
from position 3 to position 1 or 2 after programming is complete.
4. Press the remote control button, wait for a sound signal, confirming recording of the remote
control number into the controller memory.
5. Program next remote control by repeating step 4. When 7 remote controls are recorded you
will hear a trill. If fewer remote controls are to be programmed, wait until the end of single
beeps and confirmation of the end of remote controls programming.
6. Wait for 5 seconds. In 5 seconds the controller switches into the actuator control time
programming mode what is confirmed by two beeps. Then the controller emits double short
beeps, during which the programming is carried out.
7. Pressing the button of the programmed remote control increases the open lock time by 1
second. The set time (in seconds) corresponds to the number of beeps.
8. If no action is performed during 5 seconds, the controller switches from the programming
mode into the operating mode, confirming it with three beeps.
9. Determine the type of the connected actuator (normally open or normally closed) (see
Section 6).
Remote programming:
1. Connect the power cord to the power grid.
2. Press the button of the master remote control Promix-CR.TX.01 M (supplied separately)
within 5 seconds.
3. After a trill and then single beep sounds, proceed to programming according to the
aforementioned algorithm, starting from step 4.
8.
FUNCTIONAL CHECK USING THE EXAMPLE
OF ELECTRICALLY-CONTROLLED LOCK
Connect the controller to 220V power grid and close the door with an installed electrically-
controlled lock.
1. Try to open the door. It should not open.
2. Press the button of the remote control Promix-CR.TX.01 programmed in the controller, after
a beep sound the lock will be open for the programmed time. The door should open. After
the beep ends, the lock will be closed again.
To Next Page
Loading...