M350 Series User Manual 102
Configure Net-to-Net VPN Client
1. Change Mode from Disable to Enable.
2. Navigate to the Authentication IDs tab.
3. Add the authentication ID
Keep ID as blank, Type as PSK and fill the password to Pre-shared Key field.
4. Apply the changes
5. Navigate to the Connections tab.
6. Add IPsec connection
(1) Edit the phase 1 setting
(2) Change Mode from Disable to Enable.
(3) Fill the IP address of VPN server to Remote Host Field.
e.g. Remote Host: 10.0.0.1
(4) Save the changes
(5) Edit the phase 2 setting
(6) Fill up the Local Subnet and Remote Subnet.
e.g. Local Subnet: 192.168.200.0/24, Remote Subnet: 192.168.100.0/24
(7) Save the changes
7. Apply the changes
To Next Page
Loading...
