Uniwersalny tester LCD MT-7059 Proskit Instrukcja obsługi
21
Troubleshooting
Problem Solution
Check battery of transmitter, if low
battery, replace a new one.
Confirm plug is well connected.
Can’t perform cable
map
If above two ways can’t solve
problem, Instrument is damaged;
please send it back to us for repair.
Check battery of receiver, if low
battery, replace a new one.
Confirm transmitter is on “SCAN”
function.
Can’t receive the tone
signal for finding cable
If above two ways can’t solve
problem, Instrument is damaged;
please send it back to us for repair.
Perform test with
telecom switching
equipment, can’t
receive the tone signal
for finding cable
It is probable tone signal interfere
with telecom switching equipment
signal when perform cable finding
test that will effect testing result, you
can turn telecom switching
equipment power off if necessary.
Confirm plug is well connected.
Cable mapping result
is incorrect.
If reinsert plug can’t solve problem,
Instrument is damaged; please send
it back to us for repair.
The other problems.
Instrument is damaged; please send
it back to us for repair.
To Next Page
Loading...
