C. INSTALLATION AND USE
Press the multi-function button. The display will show “Loc,” indicating that
Lock Mode is active. Press the button once more to turn Lock Mode off.
1. Test if the device works
properly before installing it
permanently on the bike.
Turn on the engine and
place the device where it
will be fitted (we suggest
the outer part of the frame),
pressing two fingers firmly
on the sides of the device
with the engine idling.
The device will turn on
automatically after about 8
seconds. The hourglass
icon on the left side of the
display will start blinking.
This means that the device
has started to count.
WARNING: all digits will
blink if the device detects
an anomaly. Please contact
your dealer if this happens.
2. Clean the application
surface carefully before
installing the device. A
low-residue solvent like
acetone is recommended.
3. Recommended Positions
Frame (keep away from
spots hotter than 70°C)
4
Upper Triple Clamp
Under Seat / Subframe
(in a protected position)
To Next Page
Loading...