SPECIFICATIONS
MOTORS CUTTING CYLINDER
Standard 220 Volt 1,5kw 1 phase 762mm long x 152mm diameter
Other single or three phase motors (30” x 6”) 16 single helix
available on request reversible blades; each blade
25mm (1”) x 8 gauge.
(10 blade optional)
TRANSMISSION BOTTOM BLADE
Twin “V” Belt to countershaft then by Precision ground to less than 1.3mm
Heavy duty drive chains and sprockets to (.050”) at the cutting edge and
attached roller and cutter to the cast iron soleplate by 9
countersunk machine screws.
1mm Blade also available.
ADJUSTMENTS
Height of cut: by independent micro-adjusters
with dual lock nuts.
Cutter to bottom blade: By independent
micro-adjusters with dual lock nuts
(Precision setting bar supplied)
GEARBOX
16 Bladed Cutting Cylinder
Heavy-duty gears, 2 speed on traverse constant
Cutter revolutions. High gear 5.15km/h (3.2mph).
Clip frequency 200 clips per meter
(186 clips per yard). Low gear 3.88km/h (2.1mph)
Clip frequency 291 clips per meter (276 clips per yard)
MASS BEARINGS
(Complete with Grassbox) Sealed ball races fitted throughout
110/220 Volt – 156 kg (343 lbs) (Prepacked with Lubricant)
To Next Page
Loading...
