Step 2:
Hold the frame below the middle pivot point by the cross
struts. This is the optimal handling position for opening the
frame. Lift the frame slightly and open it by stepping back
only so far that the gable pole extends about 10 cm.
Tensioning
loops
Step 3:
Throw over and x the four corners of the fabric roof to the
outer legs.
When positioning
the fabric roof, the
gable pole should only
be extended by
about 10 cm.
TIP
The corners of the fabric roof
are easily recognisable by the
sewn-on tensioning loops. After
the rst assembly, the roof can
remain in place. However, never
store the tent in the transport
bag when it is damp.
TIP
4
ASSEMBLY
To Next Page
Loading...