COMBINATION CHANGING:
You may change your combination any time you like and as many
times as you like. Once your safe is installed you must change the
combination to a number sequence other then the Factory Combination
of 1-2-3-4-5-6 to insure security.
Your code must consist of 6 digits.
Note: Combination changes should always be done with the door
opened.
The input of the new combination is done by keying a “change key”
code. Followed by the Old Combination to validate a change and then
followed by entering the New Combination
twice to avoid a keying
error. To change the combination, do the following:
a) Press the keys “*” and then “#”. The unit will respond with a short
warbling tone and the red lamp will strobe with the tone.
b) Now key the old 6 digit combination (1-2-3-4-5-6 if this is the first
time you are changing the combination) and end by pressing “#” (a
short good combo tone will sound.)
c) Now key the first pass with your new 6 digit combination followed
by the # key, (a short good combo tone will sound.)
d) Now repeat your combination for the second time and end it with
the “#” key as before.
1. If the combination input matches the first pass, a long good
combo tone is sounded.
2. If the combination keyed does not match the first pass, the unit
will respond with a bad combo tone (4 short beeps).
e) Now test your new combination by pressing “*” your new 6 digits
combo followed by “#”.
Note: Test your New Combination several times prior to closing
and locking the safe.
Operating Instructions for the
ESL10 w/ 202A (Keypad)
Electronic Safe Lock
Rev. 011107
4
To Previous Page
Loading...