128
Press this button briefly to enable (turn
on) the ACC system.
2. ACC Speed Increase and Resume
button
• Short press: cruising speed will
increase by + 5 km/h.
• Long press: increase the vehicle
cruising speed continuously by step
of 1 km/h until the button is released.
• Press this button to resume cruising
at the set cruise speed from
previously set value before system
exit. (only available to vehicle with
ACC function).
3. Headway Increase button
Press this button briefly to increase the
cruise following distance (headway) in
ACC system (only available to vehicle
with ACC function).
4. Cancel button
Press this button briefly to cancel ACC
activation status (turn off to standby
mode) and to exit the ACC system.
5. ACC Speed Decrease button
• Short press: cruising speed will
decrease by - 5 km/h.
• Long press: decrease the vehicle
cruising speed continuously by step
of 1 km/h until the button is released.
6. Headway Decrease button
Press this button briefly to decrease the
cruise following distance (headway) in
ACC system (only available to vehicle
with ACC function).
Function Activation
To activate ACC, the following conditions
must be met at least:
• ACC system has been selected in
multimedia display screen and enabled
via OK button.
• The gear is in Drive (D) position.
• All doors, tailgate (trunk) and hood are
closed.
• The vehicle is in motion, and the brake
pedal is not applied.
• Brake system has no failure.
• Front camera has no problems, such as
high temperature, dirt or failure.
• Electronic Stability Control (ESC) system
is active.
• Electric Parking Brake (EPB) is released.
• The driver fastens the seat belt.
• Hill Descent Control (HDC) is turned off.
• Vehicle speed must be greater than 15
km/h, provided that there is no preceding
vehicle in front.
ACC Activation (vehicle is
stationary)
When the vehicle is stationary, activate the
ACC system as follows:
• Select Adaptive Cruise Control (ACC) in
multimedia display screen. Then, press
the OK button to turn on (enable) ACC
system. The longitudinal control indicator
light for the cruise system on the meter
instrument display will turn on in grey.
• Press the brake pedal or activate AUTO
HOLD function.
• Press the ACC speed increase and
resume button to activate ACC. The
cruise system longitudinal control
indicator on the meter instrument display
will turn to green.
Driving Assist
To Next Page
Loading...