Proton e.MAS 7 - Wiper Blades; Replacement of Wiper Blades

183
Wiper Blades
Replacement of Wiper Blades
• Grease, silicon and petroleum products
will affect the wiping performance of
wiper blades. Clean the wiper blades
with warm soapy water. Check the
condition of wiper blades regularly.
• Clean and wash the windshield glass
frequently. Avoid using wiper blades to
wipe when there are sands on the
windshield glass; otherwise, the wiping
effectiveness and the service life of the
wiper blades will be affected.
• If the rubber is found hardened or
cracked, or the wipers leave water
streaks or cannot wipe a certain area on
the windshield glass, replace the wiper
blades.
• Before replacing wiper blades, clean the
windshield glass regularly with certified
washer fluid of windshield and make sure
that the windshield glass is thoroughly
cleaned.
• Replace the wiper blades of the same
specification as the original wiper blades.
• Before using the wiper and if the wiper or
windshield glass is covered with ice, frost
or snow, clean the ice and snow on the
wiper and windshield glass; to avoid
damaging the wiper.
• When the windshield is dry or there are
hard objects on the surface, do not
operate the wipers. Otherwise, it may
damage the wiper blades and windshield
glass.
Replacing the Front Windshield
Wiper Blades
1. When the vehicle is stationary and the
wiper combination switch is in
position, click the following on the
multimedia display in sequence: Vehicle
Settings → My Car → Maintenance and
Repair; then turn on the front wiper
service position function in this
interface, and the wiper automatically
moves to the service position;
When the front wiper or the front
windshield washer is activated, the
front wiper will return to its original position.
2. Raise the wiper arm of the front
windshield wiper blade away from the
front windshield glass.
While the front windshield wiper arm
is raised, do not open the front
compartment hood. Otherwise, the wiper
arm or the hood may be damaged.
Maintenance and Repair