8.8. Will it be reconnected automatically after shutdown?
2.4G connection mode: when Dongle is connected to the
terminal equipment and the scanner has not established a
new connection with other terminal equipment, the scanner
will be automatically connected after restart;
Bluetooth connection mode: the terminal equipment
establishes connection through bluetooth before the scanner
is shut down, and no one manually deletes the scanner in the
list of bluetooth devices of the terminal equipment after it is
shut down, and the scanner will be automatically connected
after it is restarted.
If automatic connection is not successful, reconnect
according to 3.1 or 3.2.
8.9 Is the red light on when charging?
Please make sure the power supply is turned on, then put
the scanner to sleep and connect with the charging device.
9. Technical support
If this manual fails to resolve your problem, please contact
your supplier.
Scanner
has been
connected
to terminal
A in 2.4G
mode
Pull
Dongle
out of
terminal A
Scanner scans
mode
configuration
code required
Dongle
connects to
terminal B or
opens the
bluetooth of
terminal B
Successful
connection
with B
Scanner has
been
connected to
terminal A in
bluetooth
mode
Turn off
bluetooth
in terminal
A
To Previous Page
Loading...