EasyManua.ls Logo

Proton SAGA 2023 - Page 149

Default Icon
356 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WARNING
(1) When working near the bat-
tery, always wear protective
eye goggles.
(2) The battery electrolyte is very
corrosive. Do not let the bat-
tery come in touch your eyes,
skin, clothing or the painted
surfaces of the vehicle. Immedi-
ately flush any spilled electro-
lyte with water.
(3) Always obey the procedure
how to disconnect and connect
the battery cables.
(4) Do not disconnect the battery
while the engine is running,
the electrical components may
be damaged.
(5) Do not disconnect the battery
with the ignition switch is in
the "ON" position.
(6) Do not cause a short-circuit to
the battery.
(7) The battery operates correctly
in a high clean electrolyte. Any
contamination to the electro-
lyte will reduce the battery
performance.
(8) Do not smoke or cause an open
flame near the battery.
(9) Ensure good ventilation when
changing or using the battery
in a closed space.
(10) When quick charging discon-
nect the battery cables.
(11) Always disconnect the negative
(-) terminal first.
Brake and clutch fluid check
Check the brake and clutch fluid level
in the reservoir tank.
DOIQW010R11001
Must be regularly checked the brake and
the clutch system for any leakage.
The fluid level must be between the
MAX" and "MIN" marks on the reser-
voir tank.
NOTE
Use brake fluid with DOT3 or DOT4 only.
Fluid level
The fluid level falls with the wear of the
brake pads. This condition does not in-
dicate any problem.
If the fluid level quickly falls, a fluid
leakage in the brake or clutch system
may have occurred. Immediately go to
an authorised PROTON service outlet for
inspection.
The fluid is hygroscopic; Easily absorbs
moisture from the air. Any moisture in
the fluid will cause an effect to the
brake system and reduce the brake per-
formance. The fluid reservoir has a spe-
cial cap to prevent the entrance of air.
Do not remove this cap. Fully tighten
the cap to prevent contamination from
particles or moisture.
There is a float that monitors the fluid
level. When the fluid level is below the
"MIN" mark, the brake warning light at
the meter display will illuminate.
Fuel lines, engine coolant hoses and
exhaust gas leakage
Look under the vehicle body.
1. Check the hoses and joints for any
leaks of engine coolant, oil and ex-
haust gas.
143
Identifier: MANOWN001SAGAMC2DOMASEAN Generated: 27.09.2022 11:44:41 a.m.

Table of Contents