Proton SLR mini 3060 - Page 59

Page 59 of 126
Proton Products SL mini and SLR mini Series Speed and Length Gauges Instruction Manual - issue 1s
3
Configure the CANbus interface as required and click the “Exit” button when complete:
Label
Value
Description
CAN ID
0 ~ 255
Enter the CANbus address for the gauge.
CAN
Terminator
OFF
If the gauge is not located at the end of the CANbus, then select “OFF” to
disable the internal termination resistor.
ON
If the gauge is located at the end of the CANbus and no external termination
resistor has been installed, then select “ON” to enable the internal
termination resistor.
CAN Baud
Rate
250
Select the required CANbus baud rate (in kbps).
500
1000
Configuration via input parameters:
This interface may be configured by writing to the following input parameters:
Input parameters
DW
Bit
Comment
Unit
Range/Remark
Default
21
CAN address
1=1
0~255
14
22
CAN baud rate
0=250
1=500
2=1000
other=500
2
36
CAN terminator
1=1
0=Off
1=On
0