Shows up when connected to 230V power supply and the internal
battery is getting charged. The display also shows the percentage
already charged.
Shows the charging level of the internal battery. At least 80% are
recommended to jump start a car.
Indicates that the internal battery is low, please recharge.
When pressing the Light Switch once, the steady light will come up.
When pressing the Light Switch twice, the strobe light will come up.
When pressing the Light Switch three times, the SOS warn light will
come up.
USB port 1 and 2 are ready to power or charge a connected USB
device.
Shows that the clamps are connected incorrectly. At this time the
start is prevented. Please remove the clamps and connect them the
right way. The red clamp must be connected to the positive (+)
terminal and the black clamp to the negative (-) terminal of the
battery. If you are sure that the connections are correct but this
warning still shows up, press the Power button for three seconds to
ignore this warning.
SHORT CIRCUIT
CHECK ALL CONNECTIONS
Shows up if the LI1200A indicates a short circuit. At this time starting
is prevented. Please remove the clamps and press the Power button
for three seconds before reconnecting the clamps to the battery.
Shows up when the LI1200A is connected to a 12V battery and is
ready to jump start. If the LI1200A cannot detect the battery or the
battery is too low to be detected, you may use the “Expert Mode” for
manually choosing your 12V battery type and jump start your 12V
car battery.
Shows up when the LI1200A is connected to a 24V battery and is
ready to jump start. If the LI1200A cannot detect the battery or the
battery is too low to be detected, you may use the “Expert Mode” for
manually choosing your 24V battery type and jump start your 24V
car battery.
To Next Page
Loading...