-10-
Note:
Foroptimal grinding, apply requisite uniform
speed. Applying excessive pressure does not
achieve improved grinding results and increases
heatbuild-up.
Note:
In the event thatmachine overheats, switch it off
immediately and allowtocool.
Maintenance, cleaning and care
Attention:
Disconnect the mains plug prior to every
adjustment, maintenance measure or repair!
Note:
Everydevice is dirtied by dust when working with
wood. Cleaning is therefore essential. To ensure a
long service life, however,the machine should be
cleaned with asoft cloth or brush after each use.
Mild soaporother suitable cleaning agent may be
used in this context. Solvents or cleaning agents
containing alcohol (e.g. petrol, cleaning alcohols,
etc.) should be avoided, since these can attack
plastic casings.
The apertures required for cooling the motor must
always be kept free of dust and dirt.
Accessories
Formore detailed information on accessories,
please request our device catalogue from the
address specified on the last page in the warranty
information.
Please note in general:
PROXXON bits and cutters have been designed to
work with our machines, which makes them opti-
mal for their use.
We will not assume anyliability whatsoever for the
safe and proper function of our devices when using
third-party bits and cutters!
Service note
Please note: The mains power input may only be
replaced by our PROXXON Service Department or a
qualified specialist!
Disposal:
Please do not dispose of the device in domestic
waste! The device contains valuable substances
thatcan be recycled. If you have anyquestions
about this, please contact your local waste man-
agement enterprise or other corresponding munic-
ipal facilities.
EC Declaration of Conformity
Name and address: PROXXON S.A.
6-10, Härebierg
L-6868 Wecker
Product designation: OZI/E
Article No.: 28520
In sole responsibility,wedeclare thatthis prod-
uct conforms to the following directives and nor-
mative documents:
EU EMC Directive 2014/30/EC
DIN EN 55014-1 /05.2012
DIN EN 55014-2 /11.2014
DIN EN 61000-3-2 /03.2010
DIN EN 61000-3-3 /03.2014
EU MachineryDirective 2006/42/EC
DIN EN 62841-1 /07.2016
DIN EN 62841-2-4 /05.2015
Date: 08.09.2017
Dipl.-Ing. Jörg Wagner
PROXXON S.A., Machine Safety Department
The CE document authorized agent is identical
with the signatory.
To Next Page
Loading...
