17Compilation of safety notes
39 of 54
17. Compilation of safety notes
As with any other machine, there are some things that need to be observed when
operating the CNC lathe PD 400 CNC so that dangers to humans and the environment
cannot occur.
In this context, please also observe the separately enclosed pamphlet with the safety
notes.
Special noise protection This can be achieved through ear protection, a protective cell,
or a closed room. Also, clamp the tools short so they do not
vibrate so strongly
User group Persons above the age of 14 may use the system;
instructions on safety and compliance with the safety notes is
always required.
Caution!
Risk of injury! Always keep your fingers away from the rotating work piece
while turning! Never measure the work piece during operation
with a sliding calliper or similar! Do not process the work
piece during operation with a rasp or sandpaper!
Setting up the
workplace: No spatial narrowness
EMERGENCY Off pushbutton in the room
Vacuum cleaner, permanently installed
PC and machine next to each other,
Connecting cable, max. 1.5m
User group Technically capable persons who are at least 14 years of
age.
Familiarize yourself using the documents or by being
instructed.
Machining unit Due to the safety regulations, a machining unit for clamping
processing is delivered.
Changing work pieces Please observe at all costs that the machine is protected
against unintentional actuation while changing the tools or
clamping work pieces in the respective clamping device!
When changing the tools, the mains power input for the machining unit must be removed
from the mains socket!
Clamp the lathe tool as short as possible!
To Next Page
Loading...
