PROBLEM SOLVING
The A1000/A2000 is designed and manufactured for a severe environments and tasks, but the user
must note that the machine components must be protected from knocks and blows. Filter and sealing
connections are carefully chosen to serve the operator. Therefore, the machine must be handled with
care if it is to work correctly for many years.
Problem Cause Procedure
The fan does not start No power Connect the machine
Cable defective Change
Switch defective Change
The fan stops immediately Wrong fuse Connect the correct fuse
The fan runs, Blocked filter Change filter
but suction is poor Cover loose Adjust
Sealing defect Change current seal
Dust blows from unit Defective or loose filter Adjust or change
Abnormal noise Order service
Keep these instructions!
To Next Page
Loading...
Need help?
General
