How to Ride Your Bike
Starting The Engine :
• Turn the fuel tap knob to ‘ON’ or ‘RES’
position.
• Switch ‘ON’ ignition & ‘Kill Switch’
• Confirm that transmission is in neutral.
• Fold R.H side rider footrest.
• Keep throttle completely closed, press
starter button “ ” / apply kick to start the
engine.
• Release starter button / kick lever as soon
as engine starts.
• Open R.H side rider footrest back to its
position.
Warning : During kick starting if rider
footrest is not folded, kick lever hits the
footrest and severe jerk would get
experienced at foot. Also rider step holder
would get damaged due to impact.
Moving Off :
• Check that Center/Side stand is up.
• Depress the clutch lever.
st
• Shift into 1 gear.
• Open the throttle and release the clutch
lever slowly and simultaneously.
• As the clutch starts to engage, open the
throttle a little more, giving the engine just
enough rpm to keep it from stalling.
Caution : Do not operate the starter
continuously for more than 5 seconds
otherwise battery would get discharged.
Wait 15 sec. between each operation of
the starter which will facilitate battery to
recover.
Note : Do not let the engine idle longer than 3
minuets otherwise it will overheat.
Note : The motorcycle is equipped with a
starter lockout switch. This switch ensures that
engine does not start if the transmission is in
gear.
However, the engine can be started in any
gear if the clutch lever is pressed.
Before starting the engine, in ignition key
off condition, press the clutch lever & operate
kick starter lever all the way down for 5-6 times.
Then release the clutch lever.
This practice ensures lubrication of clutch
components for their longer life.
Note :
16
To Next Page
Loading...