EasyManua.ls Logo

Pulsar 135 LS - Page 53

Pulsar 135 LS
54 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Applicable to all Paid Services
Note : Above jobs are applicable as per Periodic Maintenance Schedule.
Servicing
Kms
* It is strongly recommended to use only “Bajaj DTS-i 10000” Genuine engine oil. In case any other engine oil of
same specifications is used, the frequency of Sr. No. 2, 3 & 4 will be every 5000 Kms.
Sr No. Jobs to be carried out 1st Paid 2nd Paid 3rd Paid 4th Paid
14500~15000 19500~20000 24500~25000 29500~30000
51
52
53 Start engine, check & adjust horn & all lights, auto choke**
for proper functioning
52 Check oil pressure indicator on speedo console.**
53 Check & clean ignition switch contacts if operation sticky.
54 Check, Clean & lubricate Clutch switch & brake switch
(Horizontal base) contacts.**
55 Check clutch switch (vertical base)-replace if required**
56 Check & adjust gap between reed switch & TPS magnet.**
57 Check & Tighten St. Motor , St. Relay & H.T. coil connections.
58 Check & adjust idling and CO%. Tune engine
& carburettor if required.
59 Carry out any additional work if required.
60 Check tyre wear & inflate air pressures in the tyres.
61 Test ride the Vehicle & Clean vehicle at the time of delivery.
Check Cap steering bearing(Plastic), replace if required.
Check & Clean Step-Pillion LH & RH (ball and plate)*