Pulsar Superglide User Manual

Glass feet are consumable parts, similar to other PTFE feet.

Glass feet can wear over time and may break or crack if dropped or hit.

Glass feet will not break naturally or during normal usage.

Do not use if broken or cracked. Stop use, clean surface, vacuum debris.

Use caution with sharps, avoid direct hand contact, use tools for debris.

Do not use with glass mouse pads.

Remove the current skates from your mouse.

Clean the mouse surface to ensure no residue remains.

Attach the new Superglide skates to the mouse.

Press firmly on the attached skates for 2-3 seconds.

Do not use your finger or nail to remove the superglide skates.

Use a thin plastic prying tool to safely remove the skates.

Using adhesive removers or cleaners will damage the adhesives.

Gently and slowly lift the superglide from the edge using a prying tool.

Contact support via email (support@pulsar.gg) or website for assistance.