Need help?Do you have a question about the Pulse Shower Spas 1010 and is the answer not in the manual?
Locate mounting points, mark wall for holes, and drill 1/4" wide by 1" deep holes 22 5/8" apart.
Insert wall anchors, slide top and lower mounts onto the slide bar, and secure with screws.
Slide soap dish onto the bar. Connect hose and handshower to the diverter outlet using washers.
General| Model Number | 1010 |
|---|---|
| Finish | Brushed Nickel |
| Hand Shower | Yes |
| Thermostatic Valve | No |
| Diverter | Yes |
| Spray Patterns | Multiple |
| Flow Rate | 2.5 GPM |
| Installation Type | Wall Mounted |
| Material | Aluminum |
To Next Page
